Industry information

Home  > INFO CENTER  > Industry information  > 

Vacuum coating equipment is more and more widely used

Vacuum coating equipment is more and more widely used

2020-08-11

Vacuum coating equipment is more and more widely used

With the progress of social economy and science and technology, people's requirements for the quality of life have been gradually improved. At the same time, people's awareness of environmental protection has become stronger and stronger. So in recent years, the products processed by vacuum coating technology are more and more extensive and life-style. At the same time, many countries have also issued relevant policies, stipulating that electroplating technology that pollutes the environment is not allowed to be used. Since 1992, Guangdong Zhenhua Technology Co., Ltd. has been focusing on the research and development of vacuum coating technology and the research and manufacture of vacuum coating machine. It strongly advocates that the products requiring surface treatment are processed by vacuum coating machine, which can not only make the products get better appearance but also protect the environment. 


vacuum coating machine


Maintenance and maintenance

1. The working room should be cleaned every time the vacuum coating equipment completes more than 200 coating procedures. The method is: use a saturated solution of caustic soda (NaOH) repeatedly

Vacuum coating equipment

Vacuum coating equipment

Scrub the inner wall of the vacuum chamber (note that the human skin should not directly contact the caustic soda solution to avoid burns). The purpose is to make the coated aluminum (AL) react with NaOH. After the reaction, the film will fall off and release hydrogen. Then clean the vacuum chamber with clean water and clean the dirt in the fine suction valve with a cloth dipped in gasoline.

2. When the rough pump (slide valve pump, rotary vane pump) works continuously for one month (half in the rainy season), new oil needs to be replaced. The method is: unscrew the oil bolt, drain the old oil, and then start the pump for a few seconds to completely drain the old oil in the pump. Tighten the oil plug and add new oil to the rated amount (observed by oil sight glass). After using for more than half a year, the oil cap should be opened when changing the oil, and the dirt in the tank should be wiped with a cloth.

3. The diffusion pump has been used continuously for more than 6 months, the pumping speed is obviously slow, or the operation is improper, fill the atmosphere, remove the coupling water pipe, remove the electric stove plate, unscrew the first-stage nozzle, first use gasoline to pump the pump cavity and pump Clean the tank again, then wash it with washing powder and water, and then rinse thoroughly with water. After the water evaporates, install the pump tank, add new diffusion pump oil, and install it back to the body, connect the water pipe, and install the electric stove Disk, you can reboot. Before restarting, pay attention to leak detection. The method is: start the maintenance pump and close the door. After a few minutes, observe whether the vacuum degree of the diffusion pump reaches 6X10 Pa. Otherwise, leak detection is required. Check whether the joint is equipped with a sealing rubber ring, or the sealing ring is crushed. Heat up after removing the hidden danger of air leakage, otherwise the diffusion pump oil will burn the ring.




Vacuum coating equipment/PVD Vacuum coating machine/Vacuum coating equipment/PVD Vacuum coating machine

Chat Online 编辑模式下无法使用
Chat Online inputting...