Industry information

Home  > INFO CENTER  > Industry information  > 

There are two possibilities for why the vacuum coating machine is getting slower and slower

There are two possibilities for why the vacuum coating machine is getting slower and slower

2021-02-26

There are two possibilities for why the vacuum coating machine is getting slower and slower.

 

   1. Due to the long time coating inside the equipment, some dirt will vent gas during heating. Therefore, maintenance is required in this case, that is, remove the internal shielding plate by sandblasting or stripping and clean it thoroughly.

 

  2. Small leaks are not found, especially the sealing of each transmission part. This situation is more difficult to check. If there is no leak detector, only part of it can be removed or replaced with blind plates to eliminate it. Some people use the needle to inject alcohol to observe the change of the vacuum gauge, but it is generally difficult to judge when the leakage is not large. As for the vacuum 1.9 that you said is actually not high, the leakage rate is based on the volume of your equipment. And the degree of vacuum drop per unit time is not calculated according to the vacuum value. For example, if your vacuum pump has a good pumping speed and a strong pumping capacity, it is possible to overcome the slight leakage and make the vacuum display a higher value.


vacuum coating machine

Chat Online 编辑模式下无法使用
Chat Online inputting...